What Is Carbon Monoxide

Because the heating season is right around the corner, I think it’s important to inform as many as possible about this toxic gas. The reason is because  carbon monoxide (CO) will take the life of 10,000 individuals this year alone, sending 20 to 40,000 more to the hospital. This gas has no odor, color, or taste; so it cannot be detected by bodily senses..

 

(CO) is produced by incomplete combustion of fossil fuels . Inhaled carbon monoxide is absorbed into the blood. It combines with the hemoglobin in the blood to a much greater extent than oxygen does; it will then reduce the oxygen – carrying function of the blood. You now know why carbon monoxide is ranked #1 for accidental poisoning deaths in the United States. How is carbon monoxide formed? How is it measured? How can I be sure my home is safe? What can I do to reduce the risk?  These questions will be answered and more. Stay tuned for the next article.

 

How Often should your heating system be cleaned?

It is recommended by boiler and furnace manufacturers that your heating system be serviced once a year. During this time, the technician should perform the following:

 

1)      Remove chimney cap and inspect the base of the chimney to ensure flue gases are escaping properly.

2)      Check all electrical controls and wiring.

3)      Remove all dirt sitting at the base of the chimney and burner assembly.

4)      Make a visible inspection of circulating pump, pipes and fittings around heater.

5)      Watch pressure/temperature gauge and add water if necessary.

6)      Replace thermocople and/or filter.

7)      Inspect safety relief valve and discharge pipe for signs of leakage.

8)      Make sure shutoff valves, switches and thermostat work properly.

 

By having this type of service done once a year, you prevent small problems from turning into expensive repairs, reduce the risk and discomfort of having no heat at all, and increase the efficiency and life of your heater. Failure to have your heater serviced annually by a skilled technician could result in equipment failure, severe personal injury or substantial property damage.

 

If you have any questions about your plumbing and heating system, please send them to service@precisionplusplumbing.com

Tips For Your Plumbing System In The Winter

When temperatures dip below freezing for an extended period of time, plumbing problems are most likely to occur. Here are some tips Tips For Your Plumbing System In The Winter.

* Always insulate pipes in unheated or poorly heated portions of your home. This will help prevent frozen pipes and burst pipes.

* Insulate your water heater. A plumber can best help you withi this process.

* Seal off anywhere that has air coming in. Seal in cracks or holes in your basement or crawlspace to prevent the cold from getting in.

* The cabinet beneath your sink should be opened at night to allow warmer air to heat the area. This will prevent frozen or broken pipes under your sink.

* Always disconnect outdoor plumbing elements such as hoses.

* Educate yourself on where you water shut off valve is for the house. In case of an emergency, such as a burst pipe, knowing where this is can help prevent thousands in damage.

If you need assistance for any of these items we are here to help. Tips For Your Plumbing System In The Winter can save you thousands from plumbing emergencies.

How To Prevent Frozen Pipes Or Burst Pipes (Winter Plumbing Problems)

When temperatures dip below freezing for an extended period of time, plumbing problems are most likely to occur. Here are some tips to prevent winter plumbing problems such as frozen or burst pipes.

* Always insulate pipes in unheated or poorly heated portions of your home. This will help prevent frozen pipes and burst pipes.

* Insulate your water heater. A plumber can best help you withi this process.

* Seal off anywhere that has air coming in. Seal in cracks or holes in your basement or crawlspace to prevent the cold from getting in.

* The cabinet beneath your sink should be opened at night to allow warmer air to heat the area. This will prevent frozen or broken pipes under your sink.

* Always disconnect outdoor plumbing elements such as hoses.

* Educate yourself on where you water shut off valve is for the house. In case of an emergency, such as a burst pipe, knowing where this is can help prevent thousands in damage.

If you need assistance for any of these items we are here to help. Remember, the best way to prevent plumbing problems is prevention.

What To Do If You Need Hot Water Heater Repair In Philadelphia

By Derrick Jackson

4 Things you can do right now if you have an electric water heater, and no hot water….. or you can call us and we can do it for you! . . Hot water heater repair

To make things as easy as possible, I have tried to break things  down into a few steps. Before you even consider trying to determine what is wrong with your  “electric water heater”, you must have an electronic volt meter  to properly inspect both controls. If you are uncomfortable with testing electrical circuits, please do not read any further and get professional advice.

 

Step 1

Locate the electric panel in your home or condo and you want to find the breakers that are marked for water heater. Please note, just because it says “electric water heater” does not mean that it is accurate. In many cases, it may not be marked at all.

 

Step 2

While the breaker is still in the on position, remove the upper plates on the tank, a flat head screw driver normally does the trick. On the top, you will see a black and red wire coming down providing power to the top control. Put your volt meter on the 2 screw heads and make sure you are getting proper voltage. If you are not, seek the help of an electrician to provide proper voltage to your controls. If you are getting proper voltage, turn the main breaker off, and proceed to step 3.

 

Step 3

Confirm that the power is off by retesting for voltage. Now , starting from the top 2 controls, remove all the wires, and re-tighten the screws. Please note, take a picture 1st, to make sure that you put all the screws back properly. Use an ohm reader to test the bottom control, it should read between 11 to 15 ohms. Test the top control by placing your special meter on the  screw heads on the left, if bulb gets bright, it’s working, if it does not, it needs replacing.

 

Step 4

Now repeat those steps for the identical 2 controls at the bottom.

This is the fastest way that I know of to determine what is wrong with your “electric water heater”. There are still other things to take into consideration, such as….  how old is your existing water heater? Does it make sense to repair, or simply replace? If one of the failed parts went bad, does it make sense to replace the same upper or lower control part as well.

Part 2 of this equation is how much is your time worth? Just because you know how to “troubleshoot”, or “fix it”, does not always mean that you should. My last tip is that if the bottom of the upper, or lower control fails, it requires a special tool to remove. Please make sure to properly drain the tank first, and properly fill before turning the power back on.

The Three R’s: If You Suspect You Need Gas Leak Repair Philadelphia

Recognize Gas Leak Repair

Signs of a natural gas leak include:

  • A “rotten egg” odor
  • A blowing or hissing sound
  • Dead or discolored vegetation in an otherwise green area
  • Flames, if a leak has ignited
  • Dirt or dust blowing from a hole in the ground
  • Bubbling in wet or flooded areas

React: Gas Leak Repair

If you suspect a natural gas leak in your Philadelphia home, follow these steps: Gas Leak Repair

  • Leave the area immediately and call us at 215-748-7587
  • Do not use any electrical device, such as light switches, telephones or appliances such as garage door openers. They could spark and ignite the gas.
  • Do not use an open flame, matches or lighters
  • Do not try to locate the source of the gas leak
  • Do not try to shut off any gas valves or appliances
  • Do not start vehicles
  • Do not re-enter the building or return to the area until you are told its safe
  • If the natural gas ignites, let it burn. Do not put out the flame; burning gas will not explode.
  • If you are digging and think you may have damaged a natural gas pipeline, leave the area immediately. If you are using motorized equipment and can turn off the motor safely, do so to prevent the ignition of any leaking gas. Then abandon the equipment and leave the area. Never restart equipment until the surrounding environment has been checked and declared safe.

Report

It is important that you call right away if you suspect a gas leak. We are here 24/7 to provide emergency gas leak repair service in Philadelphia. Call today if you need gas leak repair.

What To Do If You Suspect A Gas Leak and Need Gas Leak Repair In Your Philadelphia Home

Since natural gas has no scent, a strong odorant that smells like rotten eggs is added to help you detect possible leaks. If you smell natural gas:

  • Remove any cigarettes or other smoking materials from the area, and then extinguish them.
  • Do NOT use matches, lighters or other open flames or activate light switches, electrical appliances, flashlights, doorbells or even garage door openers, as they could create a spark.
  • Do NOT use telephones (cellular included) on the premises where the leak is suspected. Phones can create a spark.
  • Evacuate everyone from the building immediately and then call Precision Plus Plumbing for gas leak repair.
  • Do not re-enter the building until  declared it to be safe until someone can perform gas leak repair.

For your safety, we promptly investigate suspected natural gas leaks 24 hours a day, seven days a week.

 

If you smell natural gas and suspect a small natural gas leak in your home, take the following steps:

  1. Open all doors and windows.
  2. If possible, check to see if appliance burners are fully off and pilot lights (if any) are lit.

If the odor inside is strong and you think you may have a large natural gas leak, follow these instructions:

  1. Do not try to find the leak source or turn off valves or appliances.
  2. Do not operate any electrical, battery, or mechanical devices (including phones).
  3. Leave the premises and take all occupants with you.

If you detect an odor of natural gas outside, take these steps:

  1. Stay away from the suspected leak area.

A Relationship With Your Plumber Assures Prompt Emergency Plumber Service

Plumbing problems do not give you a head’s up before they cause an issue. In fact, they often seem to occur at the most inconvenient times. This is where an emergency plumber comes in handy.

There are never enough plumbers to handle all of the plumbing issues that arise. This means that even an emergency plumber may not be available immediately when you call. There are ways to ensure the fastest service from your plumber when it’s most needed, though. This is important because a plumbing problem may mean you have water flooding your home, or that your family is without running water.

The best way to find a competent plumber you trust is to ask around. Friends, neighbors and co-workers can probably recommend someone who has helped them out in the past. Call this plumber before you have a problem, and tell him that you will be calling him again when you need plumbing work. Exchange numbers, and begin to build a relationship with him for emergency plumbing.

Even if you don’t have any plumbing needs, it is important to stay in touch with your plumber regularly. Send a card on holidays, call occasionally just to keep in touch, and make sure he knows when you recommend his services to others. The relationship you build will benefit you when a plumbing emergency happens in your home.

When a plumbing issue arises, call your plumber immediately. Explain the issue to him, and let him know how he can help you. Because you have an existing relationship, he will come to your aid as quickly as possible with emergency plumbing service.